B-2 Axles-lubrication of
oscillation bushes
Set the vehicle in the parking position. Make
sure no one approaches the work area.
Stand near the front axle oscillation bushes.
Inject grease in the grease nipples present on
both sides of the axle (front and rear).
Repeat the lubrication for the rear axle.
B-3 Hydraulic oil level-check
For correct working of the machine, check to
make sure the level of oil in the hydraulic
system is sufficient. Incorrect level of oil in the
hydraulic system can damage the components.
Daily inspections will make it possible to detect
changes in the oil level which could indicate
the presence of faults in the hydraulic system
1 Make sure the boom is in the retracted
position.
2 Check the oil level indicator on the side of
the hydraulic tank.
Result: the oil level in the hydraulic system
must be near the centre line of the level
indicator present on the tanks.
Add oil if necessary. Do not exceed the level
indicated.
Note：The hydraulic oil should be applied to
the local environment, and be filtered at the
accuracy of 20μm.
To Next Page
Loading...
