B-4 Telescopic booms sliding
blocks - Lubrication
1 1. Position the machine in an area with
sufficient clearance around it; centre the
turret and bring the telescopic boom to the
horizontal position. Extend the telescopic
boom completely.
2 2. Remove the dust guard gaskets at the
head of the extension and clean all the
sliding surfaces thoroughly.
3 3. Using a brush, apply a thin layer of
grease on the sliding surfaces on all four
sides of the boom. Repeat the operation
for each stage of the extension.
4 4. Retract and extend the telescopic boom
a number of times to distribute the grease
uniformly.
5 5. Remove excess grease to prevent dirt
build-up and refit the dust guard gaskets.
6
Fuel is flammable and can cause severe
burns and death.
Do not smoke or use naked flames while
working on the fuel line.
Clean the engine parts and engine
compartment to remove all traces of fuel to
prevent risk of fire.
Deutz pre-filter-draining water
(1) Pump fuel supply
(2) Bleed screw
(3) Electric connection for the
water level sensor
(4) Drainage cap
(5) Filter cartridge
(6) Fuel tank inlet
1 Stop the engine.
2 Place a suitable container.
3 Disconnect the cables.
4 Slacken the drainage screw.
5 Drain the liquid until the pure diesel fuel
starts flowing out.
6 Fit the drainage cap by applying a
tightening torque of 1.6±0.3 Nm.
7 Reconnect the cables.
To Next Page
Loading...
