D-5 Turret rotation slewing ring
gear - check tightening of bolts
Check the turret fixing nuts on the slewing ring
gear. Check for rusted, slackened or missing
nuts.
Contact your dealer in case of serious
problems.
To check the tightening torque slacken lock
nuts1. Tighten nuts 2 by applying a 290 Nm
torque. Again tighten lock nut 1. The help of a
second operator may be necessary to hold the
screw steady.
To check the fixing screws of the slewing ring
gear on the chassis, align hole 3 with the
screw underneath by rotating the turret.
Tighten the screws by applying a 290 Nm
torque. Repeat the operation for each screw,
rotating the turret from time to time.
E-1 Fuel filter - replacement
1 Slacken the filter using the tool and
unscrew it.
2 Collect the fuel that flows out.
3 Wipe the surface of the filter-holder with a
clean cloth that does not leave lint.
4 Oil the original DEUTZ filter cartridge seal
slightly.
5 Screw the manual filter by hand until it is
tight
6 Tighten the clamps of the anti-twisting
safety (optional).
7 Bleed the fuel supply system.
To Next Page
Loading...
