During operations on the lubricant oil system,
ensure utmost cleanliness. Thoroughly clean
the area around the components concerned
from time to time.
Dry the damp parts with air jets. For handling
lubricant oils follow the safety directives and
specific local standards.
Dispose of the leaked lubricant oil and the filter
elements. Do not let the used lubricant oil
spread in the ground. Run a test cycle after
every intervention. At the same time, ensure
sealing and pressure of the lubricant oil and
then check its level.
An insufficient and/or excessive lubricant oil
level can damage the engine. Check the oil
level only with the engine horizontal and
stopped. Check the lubricant oil level only
while it is warm, 5 minutes after the engine is
switched off. Do not remove the oil level rod
with the engine running. Danger of burns.
Changing the engine oil
1 Heat the engine until the oil temperature
reaches > 80° C.
2 Park the vehicle on a horizontal surface
and stop the engine.
3 Place a container under the drain screw,
unscrew the latter and drain out the
lubricant oil.
4 After draining, reposition the screw with a
new sealing ring and tighten by applying a
55 Nm torque.
5 Fill lubricant oil, warm the engine to a
temperature > 80° C and check the
lubricant oil level.
6 Top up, if necessary.
Replacing the lubrication oil cartridge
1 Slacken the filter using the tool and
unscrew it.
2 Collect the lubricant oil that flows out.
3 Wipe the surface of the filter-holder with a
clean cloth that does not leave lint.
4 Oil the original DEUTZ filter cartridge seal
slightly.
5 Screw the manual filter by hand until it is
tight.
To Next Page
Loading...
