Wire mesh filter
1 Remove the cover 1 from the hydraulic
tank.
2 Clean the area around the cover of the
hydraulic oil reservoir.
3 Use a wrench to loose and remove the
bolts from the hydraulic oil reservoir cover,
move the cover away from the reservoir,
then turn the filter element 2 from the
adaptor.
4 Take a new filter element to screw it onto
the filter adaptor.
5 Install the covers back, and screw down
bolts.
PLFA filter (outlet of pump)
1 Clean the area around the oil filter, and
then remove the cap components.
2 Pull out the filter element from the filter
assembly chamber.
3 Install the new filter element to the filter
assembly chamber.
4 Refit the cap components and tighten it.
Clean up any oil that may have spilled
during the replacement procedure.
PLFA filter
（
Inlet of upper control
valve
）
1 Clean the area around the oil filter, and
then remove the cap components.
2 Pull out the filter element from the filter
assembly chamber.
3 Install the new filter element to the filter
assembly chamber.
4 Refit the cap components and tighten it.
Clean up any oil that may have spilled
during the replacement procedure.
To Next Page
Loading...
