B-7 Wheels - check tightening of
nuts
It is extremely important to apply and maintain
proper mounting torque.
Tighten the lug nuts to the proper
torque to prevent coming loose.
Wheel nuts should be torque after first 50
hours of operation and after each wheel
removal. Use a torque wrench to tighten
fasteners. If you do not have a torque wrench,
tighten the fasteners with a lug wrench, then
immediately have a service garage tighten the
lug nuts to the proper torque. Over-tightening
result in breaking the studs or permanently
deforming mounting stud holes in the wheels.
The proper procedure attaching wheels is as
follows:
1 Set the torque wrench to 450Nm.
2 Tighten nuts in the following sequence:
3 When there is sound like ‘kada’, the lug
nut is fastened at proper torque.
B-8 Radiator-cleaning by
rotating reversely
The radiator should be cleaned termly for
cooling effectively. There is a method for
cleaning the radiator easily.
Cooling fan reverse
The setting interface could be entered by
depressing setting button and hold on for one
second. Cooling fan reverse can be activated
as follows:
1 Depressing or
is used to change the item. Chose F509.
The chosen item would be shown in
yellow background.
2 Depressing and holding on
for one second is used to turn on or off
corresponding function.
3 Save the modified value by depressing
the button .
4 Modifying “F509 cooling fan reverse”, is
only valid in condition of power on. It will
To Next Page
Loading...
