DINGLI S03-E - At the Ground Controls; At the Platform Controls

OPERATOR’S MANUAL with Maintenance Information
Function Tests
16
1 Select a test area that is firm, level and free
of obstruction.
2 Be sure the battery pack is connected.
At the Ground Controls
3 Pull out the platform and ground red
Emergency Stop buttons to the on position.
4 Turn the key switch to ground control or
platform control position.
☉ Result: The LED will light.
Test Emergency Stop
5 Push in the ground red Emergency Stop
button to the off position.
☉ Result: The LED indicator will turn off and no
functions should operate.
6 Pull out the red Emergency Stop button to
the on position.
Test Up / Down Functions
7 Turn the key switch to ground control
8 Press the platform up button.
☉ Result: The platform should raise.
9 Press the platform lower button.
☉Result: The platform should lower. The
descent alarm should sound while the platform
is lowering.
Test the Emergency Lowering
10 Activate the up function and raise the
platform approximately 60 cm.
11 Pull the emergency lowering knob located
the ground control side .
☉Result: The platform should lower. The
descent alarm will not sound.
12 Turn the key switch to platform control.
At the Platform Controls
Test Emergency Stop
13 Push in the platform red Emergency Stop
button to the off position.
☉ Result: No functions should operate.
14 Turn clockwise and release to reset
Emergency Stop
Test the Horn
15 Push the horn button.
☉ Result: The horn should sound.
Test Up / Down Functions and
Function Enable
16 Press and release the Platform Function
Button to active lift function.
☉ Result: The flashing LED indicates the
function is active and will remain active 3 to 4
seconds.
17 Move the control handle forward or
backward
☉ Result: The platform should not raised.
18 Press and hold the function enable switch
on side the Joystick, move the control
handle forward.
☉ Result: The platform should raise.
19 Press and hold the function enable switch
on side the Joystick, move the control
handle backward direction.
☉ Result: The platform should lower then stop
at the height is 0.9 m.
20 Wait for seconds. Move the control handle
backward direction to lower the platform
fully