DINGLI S03-E - Emergency Stop; Operation from Ground; Operation from Platform; Emergency Lowering

OPERATOR’S MANUAL with Maintenance Information
Operating Instructions
22
Emergency Stop
Push in the red Emergency Stop button to the
off position at the ground controls or the
platform controls to stop all machine functions .
Repair any function that operates when either
red Emergency Stop button is pushed in.
Operation from Ground
1 Pull out both ground and platform red
Emergency Stop buttons to the on position.
2 Be sure the battery pack is connected
before operating the machine.
3 Turn the key switch to ground control.
To Position Platform
1 Press the platform up button to raise the
platform.
2 Press the Platform down button to lower the
platform.
Drive and steer functions are not available from
the ground controls.
Operation from Platform
1 Pull out the ground and platform red
Emergency Stop buttons to the on position.
2 Press and release the Platform Function
Button to active lift function.
3 Be sure the battery pack is connected
before operating the machine.
To Position Platform
1 Press and hold the function enable switch,
Move the control handle forward to raise the
platform.
2 Press and hold the function enable switch,
Move the control handle backward to lower
the platform.
To Steer
1 Press and release the Platform Function
Button to active drive function.
2 Press and hold the function enable switch,
Move the control handle left to turn the
machine to left direction.
3 Press and hold the function enable switch,
Move the control handle right to turn the
machine to right direction.
To Drive
1 Press and release the Platform Function
Button to active drive function.
2 Press and hold the function enable switch,
Move the control handle forward direction.
3 Press and hold the function enable switch,
Move the control handle backward
direction.
4 Increase speed: Slowly move the control
handle off center.
Decrease speed: Slowly move the control
handle toward center.
Stop: Return the control handle to center or
release the function enable switch..
Machine travel speed is restricted when the
platform is raised.
Emergency Lowering
At the Ground Controls
In the event of a power failure, use the backup
auxiliary lowering function.