TPW
15
Safety devices
USER_MAN_ENG_TPW_v4
SAFETY DEVICES
Noise
Noise measurements have been carried out in accordance with the provisions of standards UNI EN 11200 and UNI
EN ISO 3746.
During the operating cycles, under conditions of perfect functioning and maintenance and on a smooth industrial
surface, noise exposure of the personnel is less than 70 dB .
It is the user's responsibility to apply the resulting preventive and protective measures, in compliance with the
legislation of the country where the machine is installed and used.
Vibrations
The vibrations produced by the machine, according to its mode of operation, are not dangerous to the health of the
operators.
WARNING!
Excessive vibration can only be caused by a mechanical fault that must be immediately reported and
eliminated, in order not to compromise the safety of the line and of the operators.
Residual risks
The machine has been designed to assure the essential safety requirements for the operator.
Safety has been integrated into the design and construction of the machine as far as possible; however, risks from
which operators must be protected remain.
For each residual risk, a description of the risk and of the zone or part of the machine subject to the residual risk is
provided (unless it is a risk valid for the entire machine). Procedural information on how to avoid the risk and on the
correct use of the personal protection devices provided and required by the Manufacturer is also provided.
Risk Description and procedural information
Risk of crushing
The risk of crushing lower limbs under the load during its descent remains.
Risk of load
falling
The risk of load falling and crushing during handling operations remains.
To Next Page
