Forward-Facing Installation
46
Forward-facing Lap Belt Installation
(cont.)
Slide the seat belt through
the forward-facing belt path
behind the fabric and buckle
it. Be sure belt is not twisted.
Put seat belt in locking
mode, if necessary.
Push down on the bottom of
the car seat while pulling all
the slack out of the belt. It is
best to do this close to the
buckle. Be sure belt is locked
and the car seat does NOT
move more than 1 inch
side-to-side, front-to-back at
the belt path.
To check for a tight fit, grab at
label that states “forward-
facing belt path” with one hand and give it a moderate tug. It
should move less than 1 inch side-to-side, back-to-front.
Remove slack from Top Tether strap if an appropriate anchor is
available (See page 47 for Top Tether installation).
❒ See final checklist on page 50
To Next Page
Loading...
