Additional Information
56
Cleaning harness straps
Cleaning harness buckle
Remove center buckle from car seat (See pages 27-28).
Rinse thoroughly in mildly hot
water or soak overnight to
loosen dried liquid or hardened
food debris. Do NOT get the
buckle strap wet. Carefully rinse
only the buckle mechanism.
(Figure 1)
Towel dry.
Confirm proper buckle
functioning: repeatedly fasten
and un-fasten buckle with both tongues. If no ‘click’ is heard
confirming proper engagement after inserting each buckle
tongue, repeat cleaning procedure.
If child eats or drinks in car seat, periodically clean harness buckle
to insure proper functioning.
Clean with damp cloth only. Wet cloth with warm water and
mild soap. Wring cloth thoroughly so it is NOT dripping water.
Towel dry.
Important: Do NOT use solvents, bleach, or abrasive cleaners.
Do NOT soak or submerge the harness webbing.
Tip: Remove debris from release mechanism areas with soft
bristled brush.
Important: ONLY use water to clean buckle. Do NOT use
solvents, bleach, soap, abrasive cleaners or any detergents. Do
NOT soak or submerge the buckle webbing.
Cleaning and Maintenance (cont.)
To Next Page
Loading...
