Forward-Facing Installation
47
WARNING:
• In forward-facing installations, attach top tether to approved
vehicle tether anchorage points ONLY, as labeled by vehicle
manufacturer.
• If vehicle does not have tether anchorage points, consult vehicle
owner’s manual or contact vehicle manufacturer. Do NOT modify
vehicle without approval from vehicle manufacturer or
authorized vehicle dealer.
Forward-facing Top Tether Installation
For a step-by-step installation, watch our video here:
www.youtube.com/DionoUSA
Before installing car seat, remove top tether from storage
compartment and fully extend.
Tilt buckle and pull top tether adjuster strap to fully extend.
Loosely attach top tether to an approved anchorage point
in the vehicle using the hook at end of top tether strap.
Install car seat as shown in appropriate installation section.
Be sure installation is tight.
After installing car seat, pull top tether adjuster strap to
remove all slack. Some movement at the top of the car seat
is acceptable as long as the top tether strap remains tight.
Important: Diagram shows a variety of places you might find a
top tether anchor. Consult vehicle manual to locate correct anchor.
To Next Page
Loading...
