Directechs Directed DB3 - Module Programming for Convenience Only (Skip Transponder)

14
403.FORD6 3.24 2013 Ford Taurus (40-Bit)
©2022 VOXX•DEI LLC. All rights reserved.
Module programming for convenience features only (skip transponder programming)
Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
To connect the module:
1
Ensure vehicle is in a safe location and cannot move forward during programming. For vehicles
equipped with a manual transmission, make sure the gearshift is in the neutral position.
2
The harnesses must be connected in this exact order:
1. Connect the 14-pin.
2. Connect the 12-pin.
3. Connect the 10-pin.
When the LED turns on solid red, proceed with the next step.
Solid
Connect
1412
10
42
3
Press the programming button five (x5) times.
The LED turns ON solid orange.
Solid
Press &
Release x5
4
Turn ignition ON and wait until the LED turns OFF.
START
Key IN
ON
OFF
Off
5
Turn ignition OFF.
START
Key OUT
ON
OFF
You have successfully completed the module programming sequence.