chirps are heard, a zone was triggered so many times that
Nuisance Prevention® Circuitry has bypassed that zone. In either
case, the Status LED will indicate which zone was involved (see
Table of Zones section). The system will retain this information in
its memory, and chirp four or five times each time it is disarmed,
until the next time the ignition key is turned on.
The zone number is the number of LED flashes used by the system
to identify that input. The standard input assignments are listed
below, along with spaces to write in any optional sensors or
switches you have had installed.
ZONE
(Number of DEALER-INSTALLED
LED Flashes) DESCRIPTION OPTIONS
1
Instant trigger - hood pinswitch
or optional sensors
2 Instant trigger - a heavier impact
detected by the shock sensor
3 Door switch trigger
5 Ignition
If the Warn Away
®
response is triggered, the LED will not report
it.
Table of Zones
13
©
1999 Directed Electronics, Inc.
To Next Page
Loading...
