P.14 User Guide
“HomeValet
TM
”Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control. If the
vehicle has a manual transmission, it should be set into ready mode before activating the Home
Valet™.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote, but the OEM
alarm functions will remain active.
To take the system into home valet mode:
1. Press the or
button.
2. Within 3 seconds, press the and buttons simultaneously until the remote
beeps twice.
To take the system out of home valet mode:
• Turn the ignition key to the IGNITION ON (RUN) position.
The system will warn you if someone attempts to start your vehicle while it stands
in home valet mode. The parking lights will:
• Turn ON then OFF; then
Flash twice, pause; then
Flash twice again.
AUX1
Note: This 500 mA negative Aux 1 output can be used for many different applications
Priority door:
This great feature allows the user to unlock solely the driver’s door with a single press of the
button on the transmitter, and to unlock the other doors, if desired, by pressing the button for a
second time.
The output will provide a 1-second negative output when the button is pressed a second time
on the transmitter.
Horn Confirmation:
AUX 1 can be programmed to trigger the horn every time the button is pressed, or when the
button is pressed twice within 3 seconds. When horn confirmation is activated, panic mode is
enabled. If horn confirmation is disabled, panic mode will not be available.
AUX2
If configured at installation, this feature can be activated by pressing the AUX (or Shift) button,
followed by pressing and holding the lit up button to activate AUX 2.
HornTimingAdjustment
The pulse duration can be configured by your installer (from 5 ms to 200 ms).
To Next Page
Loading...
