Directed Electronics AS-2371TW-FM - Multi-car Operation Control; OEM-Style Alarm Integration; Intrusion Codes via Horn Interpretation

User Guide P.15
MulticarOperation
This option allows the owner of two vehicles, both equipped with the same Remote Car Starter
model, to control both systems with a single remote control.
To control the second vehicle:
Press TRUNK + LOCK buttons simultaneously: ----------------------------------------------------- LOCK
Press TRUNK + UNLOCK simultaneously: ----------------------------------------------------------- UNLOCK
Press TRUNK + START/STOP simultaneously: ----------------------------------------------------- START
Press TRUNK + START/STOP simultaneously: ----------------------------------------------------- STOP
Press AUX ¾ AUX ¾ TRUNK: -------------------------------------------------------------------------- TRUNK
OR
Press AUX ¾ AUX ¾ LOCK: ---------------------------------------------------------------------------- LOCK
Press AUX ¾ AUX ¾ UNLOCK: ------------------------------------------------------------------------ UNLOCK
Press AUX ¾ AUX ¾ START/STOP: ------------------------------------------------------------------ START
Press AUX ¾ AUX ¾ START/STOP: ------------------------------------------------------------------ STOP
Press AUX ¾ AUX ¾ TRUNK: -------------------------------------------------------------------------- TRUNK
Note: If the multi-level features have been modified from their default state by your installer, the
AUX button may have to be pressed once, twice or three times, according to the option you chose.
OEMStyleAlarm
The OEM-style alarm (if configured by your installer) monitors the doors, hood and ignition switch
of your vehicle. It will sound the horn if a door or the hood is opened, or if the key is turned into the
IGNITION ON position.
• To arm the OEM-style alarm, press the button on the transmitter.
-The OEM-style alarm will ONLY arm if the button on the transmitter is pressed.
The LED on the antenna will flash slowly to indicate that the OEM-style alarm is now armed.
• To disarm the OEM-style alarm, press the
button on the transmitter.
-To stop the horn from sounding if the OEM-style alarm is triggered, press the or
button, or put the system in and out of Valet Mode (See page 9).
IntrusionCodesviahorn
The system monitors the following:
• Doors
• Hood
• Ignition
Note: If an intrusion has occurred the HORN will sound for a maximum of 1 minute.
If an intrusion has occurred and
pressed, the horn provides an intrusion code corresponding to
the type of intrusion that occurred.
1x = power interruption 4x = Doors intrusion
3x = Hood 6x = Ignition
