5
©
2000 Directed Electronics, Inc.
4. Within 5 seconds, enter the new PIN code followed .
The LED will flash twice.
5. Within 5 seconds, enter the new PIN code again followed by
. The LED will light solidly for 1 second.
The new PIN code has been programmed. The programming mode is
exited if the ignition is turned off or if there is no activity for more
than 5 seconds. If the PIN code programming mode is exited before
a new PIN code is set, the unit will default to the existing PIN code.
Operation as a
Stand-Alone Starter Kill
When armed, the 103T will interrupt the starter wire when any
attempt is made to start the vehicle. The 103T can be passively or
actively armed. Passive arming occurs automatically 15 seconds
after the ignition is turned off.
To actively arm the unit:
1. Press .
2. Press (labeled ARM on the keypad). The system will
arm immediately.
The LED will flash steadily to indicate that the system is armed.
Arming
To Next Page
Loading...
Need help?
General
