Directed Electronics VIPER 3203

31
© 2009 Directed Electronics. All rights reserved.
Turn Paging off: The remote will not wake up to check for mes-s
sages with paging off in the setup remote menu.
Note: The remote will not receive trigger messages from the sys-
tem.
Turn Beeps off: The button beeps can be turned off in the setup s
remote menu. The command beeps still play normally.
Responder LE Battery Replacement
Battery
Cover
Battery
Clip
Rear View
+
1 2
1. Slide the battery cover up by ap-
plying equal pressure at its top and
bottom (the arrow on the cover indi-
cates the direction), remove the cover
from the remote control housing.
2. Gently pry up on the battery (or
batteries) to remove it from the holder.
Insert a new battery (or batteries) into
the holder and under the clip with the positive (+) side up. Replace the
battery cover. The remote control is now ready for use.
1-way Battery Replacement
Using a small 1.
flathead screwdriver,
insert into slot located
at the bottom of the
keypad and carefully
pry the front of the unit
open.