User guide P.23
To arm the OEM-style alarm, press the button on the
transmitter.
o The OEM-style alarm will ONLY arm if the button on
the transmitter is pressed.
o The LED on the antenna will flash slowly to indicate that the
OEM-style alarm is now armed.
To disarm the OEM-style alarm, press the button on the
transmitter.
o To stop the horn from sounding if the OEM-style alarm is
triggered, press the or button, or put the
system in and out of Valet mode (page 14).
Car Finder
If configured by your installer, the Car Finder option will help you locate the
vehicle by sending a pulsating signal through the horn. To hear the signal, press
and hold the or button. This will produce a pulsating signal
for the time you keep the button pressed.
Intrusion Codes via horn
The system monitors the following:
Doors
Hood
Ignition
Note: If an intrusion has occurred the HORN will sound for a maximum of 1
minute.
If an intrusion has occurred and pressed, the horn provides an
intrusion code corresponding to the type of intrusion that occurred.
To Next Page
Loading...
Need help?
General
