90
DIRECTV HD DVR RECEIVER USER GUIDE
remote works in IR mode only. Please refer back to Chapter 1,
“Using Your Remote Control” for detailed information.
NOTE: While the newer Genie (HR34, HR44 and above) HD DVRs
are RF-capable, previous model DIRECTV Receivers may also be
RF-capable.
To change your remote method of transmission from IR signals
to RF, select Settings, then Remote Control and then IR/RF
Setup. While IR transmission requires a clear line of sight to
the front of the Receiver, RF transmission lets you put your
Receiver inside a cabinet or behind solid doors and still be able
to command it from up to 200 feet away.
Receiver Mode
Select Receiver Mode if you want to use one remote to command
a second DIRECTV
®
Receiver.
Advanced Setups
Use this option to set up your remote to control 3 or more
Receivers in one room.
SATELLITE
This option is used by installers when your system is initially
set up; you should not have to use it. However, you can use this
screen to view your Receiver’s satellite signal strength\or to
repeat the satellite setup procedure.
SETTINGS
To Next Page
Loading...
Need help?
General
