DirecTV Universal Remote Control - Page 13

13
If there is no separate TV code listed, you will
need to perform the following steps to access
volume control:
a. Press and hold Setup until the VCR key
blinks twice, then release Setup.
b. Enter 9 - 9 - 3.The VCR key will blink twice.
c. Press VCR once. The VCR key will blink
twice.
6. For future reference, write down each working
device code in the below boxes:
TV/VCR
TV (if used)
DirectTV Mnl rev1 10/25/01 7:31 PM Page 13