INSTALLING BATTERIES
1. On the back of the remote control, push the
latch (as shown) and lift off the battery cover.
2. Obtain two (2) fully-charged AA alkaline
batteries. Match the + and – marks on the
batteries to the + and – marks in the battery
case, then insert the new batteries.
3. Align the cover’s tabs with the case’s holes.
Press down on the cover until the latch locks.
4. Test the remote control by pressing Power and
any device key (e.g.TV,VCR,AUX,or DIRECTV).
If the batteries are inserted correctly, the selected
device key will blink once.
NOTE: The DIRECTV universal remote control will stop operating
when the batteries are fully drained. Replacing the batteries will
restore your DIRECTV universal remote control to its full func-
tionality, complete with your favorite settings.
8
To Next Page
Loading...
Need help?
General
