DirecTV Universal Remote Control User Manual

27
CHANGING VOLUME LOCK
The DIRECTV universal remote control is set to control
volume of a device through your TV while in the TV,VCR,
or DIRECTV mode. However, in the AUX mode, you still
have separate control of of your auxilary device’s volume.
If your TV is not remote controllable, or if you would like
the volume to be controlled by a different device,you can
change the Volume Lock setting to control a volume
through a non-associated mode (e.g., through the VCR in
the TV mode).
To Change Volume Lock To The VCR Mode:
1. On the DIRECTV universal remote control,
press VCR once. Then press and hold Setup
until the VCR key blinks twice, then release
Setup.
2. Enter 9 - 9 - 3.
3. Press VCR once.It will blink twice.
4. Now, whenever you press Volume or Mute,
volume will be controlled by your VCR.
To Change Volume Lock To The DIRECTV Mode:
1. On the DIRECTV universal remote control,
press DIRECTV once. Then press and hold
Setup until the DIRECTV key blinks twice,then
release Setup.
2. Enter 9 - 9 - 3.
3. Press DIRECTV once.It will blink twice.
4. Now, whenever you press Volume or Mute,
volume will be controlled by your DIRECTV
Receiver.
To Change Volume Lock To The AUX Mode:
NOTE: Performing these steps will allow you to access the volume
control of your auxilary device in all modes.
1. On the DIRECTV universal remote control,
press AUX once. Then press and hold Setup
until the AUXkey blinks twice, then release
Setup.
continued on next page...
DirectTV Mnl rev1 10/25/01 7:31 PM Page 27

DirecTV Universal Remote Control Specifications

General

Brand	DirecTV
Model	Universal Remote Control
Category	Remote Control
Language	English