DirecTV Universal Remote Control User Manual

24
CHECKING THE CODES
If you have set up the DIRECTV universal remote control
using the Searching For Your Code procedure (on the pre-
vious page), you may need to find out which four-digit
code is operating your equipment. For example, to find
out which code is operating your TV:
1. Turn on your TV.
2. On the DIRECTV universal remote control,
press TV once. Then press and hold Setup until
the TV key blinks twice, then release Setup.
3. Enter 9 - 9 - 0.
4. To view the code for the first digit, press 1 once.
Wait 3 seconds and count the number of LED
blinks (e.g., 3 blinks = 3) and write down the
number in the leftmost TV Code box below.
NOTE: If a code digit is “0”, the LED will not blink.
5. Repeat step 4 three more times for remaining
digits. Use 2 for the second digit, 3 for the third
digit, and 4 for the fourth digit. Finish writing
down the code in the TV Code boxes below.
6. To check for other device codes, repeat steps 1
to 5, but substitute the appropriate key (i.e.,
VCR, AUX,or DIRECTV) for the device you are
checking.Write down the codes in the appro-
priate boxes on pages 10 and 12.
DirectTV Mnl rev1 10/25/01 7:31 PM Page 24

DirecTV Universal Remote Control Specifications

General

Brand	DirecTV
Model	Universal Remote Control
Category	Remote Control
Language	English