dirna Bergstrom bycool SPLIT - COMPRESSOR MOTOR

SPLIT
16
®
EN
Symptom Cause
Solution
L
The compressor does not work.
• Poor terminal connection.
• Compressor electronic module.
• Compressor defective.
• Lack of voltage in battery.
• Pressure switch defective or terminals
poorly connected.
• Relay or relay cable defective or
terminals poorly connected.
• Compressor signal cable with poor
contact.
• Correctly connect the compressor electronic module terminals (in accordance with the
attached wiring diagram).
• Replace the compressor’s electronic module.
• Replace the compressor.
• Charge or change the battery.
• Change the pressure switch or check the terminals.
• Replace the relay or check the terminals.
• Replace the cable or check the terminals.