Dirt Devil SM11 - Operation and Safety Warnings

DIRTDEVIL.CO.UK10
USING YOUR STEAM CLEANER
1. Place the microbre mop pad on the oor with the tab side facing up. Place the mop head onto the
microbre mop pad making sure the pad covers the entire mop head.
2. Plug the steam cleaner into the mains. The blue light will illuminate to indicate power on. The green light
will illuminate to indicate that the steam cleaner is ready to use.
3. Place your foot onto the mop head and pull the handle backwards to recline.
4. To produce steam, squeeze the trigger in short bursts. Don’t hold the trigger continuously to prevent
overwetting oors.
5. Move the steam cleaner slowly backwards and forwards across the oor paying particular attention to high
trac areas. Squeeze/release trigger as required.
6. After cleaning, return the steam cleaner to the upright position, lock it into place and unplug it. Allow the
steam cleaner to cool down. Hold the corner of the microbre mop pad down with your foot and lift the
steam cleaner to peel away.
Tip: If the area you are cleaning is becoming too wet, squeeze the trigger in short bursts.
USING YOUR STEAM CLEANER
1
2
1
4 5
1
3
1
1
6
WARNING: Danger of scalding
WARNING: Always unplug the steam cleaner when tting the microbre mop pad.
IMPORTANT: Never use the steam mop without a cleaning pad attached to the mop head. Never
leave the steam mop on one spot for an extended period of time or with a damp or wet microbre mop
pad attached as this may damage the oor surface.