Dirt Devil SM11 - MAINTAINING YOUR STEAM CLEANER; Tank Emptying and Maintenance

DIRTDEVIL.CO.UK16
WARNING: Unplug the steam cleaner and allow it to fully cool down before performing any
maintenance or troubleshooting checks.
IMPORTANT: Don’t leave water in the water tank between uses, as this can aect the steam
cleaner’s performance. The water tank should be emptied and rinsed with clean water after each
use.
MAINTAINING YOUR STEAM
CLEANER
EMPTYING THE TANK
1. Grip the water tank, press the tank release buttons and pull the tank to remove.
2. Pull the tab on the tank cap to open.
3. Empty any excess water in the sink.
4. Rinse the water tank with clean water and replace the cap, pushing rmly to close.
5. Replace the water tank back onto the steam cleaner.
11
Cleaning the filters
Before starting any cleaning, ensure the upright vac is not plugged into
Wash with water every month , allow at least 24 hours to dry and
make sure it is dry thoroughly before re-using
1. Remove the
dust canister.
2. Push the
release button,
open the dust
canister and
clean all parts of
the dust canister.
3. Open the dust
canister filter lid
located on top
of the canister.
4. Remove the
dust canister foam
and HEPA filter.
Shake and tap the
foam and HEPA
filter over a bin to
remove any exces s
dust.
5.
6. Allow filter to
dry for 24 hours
before putting
back into
vacuum cleaner.
7.
1
2
1
4 5
1
3
1
1
WARNING: Danger of scalding