Dirt Devil SM11 - Suitability and Surface Care; Plug and Cord Safety

DIRTDEVIL.CO.UK4
• DO NOT leave the steam
cleaner turned on or
connected to the mains when
unattended.
• The steam cleaner is
equipped with a thermostat
and a thermal cut-out. If for
any reason the steam cleaner
overheats it will switch o. If
this happens unplug the steam
cleaner, allow it to cool for at
least 2 to 4 hours and retry.
SUITABILITY
• DO NOT use on wax polished
oors or furniture, acrylic
surfaces and synthetic, velvet
or steam/water-sensitive
materials.
• Before using on a oor
or surface, refer to the
surface manufacturer’s care
recommendations. If the
surface is suitable for steam
cleaning, test for damage
on a small hidden area. If
no distortion, discolouration
or damage occurs, continue
cleaning.
• DO NOT put aromatic,
alcoholic or detergent
products into the steam
cleaner, as this may damage
it or make it unsafe for use.
Always ll the tank with cold
water only.
IMPORTANT SAFETY INSTRUCTIONS
FOR INDOOR USE ONLY
PLUG AND CORD
• Switch o and unplug the
steam cleaner at the socket
when not in use and before
conducting maintenance or
troubleshooting.
• DO NOT use with a damaged
cord or plug.
• DO NOT pick up or pull the
steam cleaner by the cord.
Always carry the steam cleaner
by the handle.
• Take care that the cord is not
kinked, pinched, pulled around
sharp corners or run over.
• Ensure the cord does not
come into contact with heat
sources or become a trip
hazard.
• When unplugging the steam
cleaner from the wall socket,
pull by the plug, not the cord,
holding the socket with your
other hand.
• DO NOT use this steam
mop if it has been dropped,
damaged, left outdoors,
submerged in water or is not
working as it should
• DO NOT use if the power
cord is damaged.
• Turn o all controls on
the steam cleaner before
disconnecting or connecting