Dish Network BASIC REMOTE - Initial Setup; Battery Installation; Connecting Remote to Receiver

3
Insert the Batteries
Remove the remote
battery cover.
Insert 4 AA batteries,
making sure to match the
plus (+) ends with the plus
markings on the battery
case.
Replace the remote
battery cover. With the
cover at a slight angle,
line up the tabs and push
down on the cover until it
is in place.
Press the POWER button
on the receiver’s front
panel.
Conrm remote operates
the receiver by pressing
other remote buttons.
1
1
2
2
3
Making the Remote Work
with the Receiver