23
Creating a message using the 12 keypad
Enter your message using the keypad.
• Where necessary, press a key repeatedly until the
required character is shown (see the table).
• For the next character, either press a different key
or wait roughly half a second to choose a new
character from the same key.
• To erase a character, press
g
.
• To move back or forward through the message, use
d
and
e
respectively.
• The top right corner shows one of three icons to
depict the character mode:
µ
upper case,
¶
lower case or
·
numerals. To change the character
mode, press
c
.
The following characters are available, in the order
shown, by repeatedly pressing each key.
1 . , : ; / - _ @ & ? ¿ ! ¡ ` ``
2 A B C Ä Â Æ Ç
3 D E F É
4 G H I
5 J K L
6 M N O Ñ ö ø
7 P Q R S
8 T U V Ü
9 W X Y Z
0 Space
*
* +/ ( ) < = > % £ $ ¥ | ¤ @ & §
# # ΓΔ Θ Λ Ξ Τ Σ Φ Ψ Ω
To Next Page
Loading...