Distech Controls EC-BOS-6AX - Page 3

Preparation
Material and Tools Required
EC-BOS-6
AX
Mounting and Wiring Instructions
Part Number: 05DI-HIBS6AX-10 Revised: February 2008
3
• Suitable screws and screwdriver for mounting DIN rail, or if DIN rail not used, for mounting bases of
EC-BOS-6
AX
controller and power module (if used).
• #2 phillips screwdriver: used to install and remove optional communications modules.
• Small flat-blade screwdriver: used for mounting or removing the EC-BOS-6
AX
from DIN rail, also for
making wiring connections to RS-485 connector, and optionally LON
®
connectors.