Distech Controls EC-BOS-6AX - Mounting on DIN Rail; Removing from DIN Rail

EC-BOS-6
AX
Mounting and Wiring Instructions
Revised: February 2008 Part Number: 05DI-HIBS6AX-10
Mounting
Physical Mounting
6
Step 5 Slide the accessory along the DIN rail to connect its 20-position plug into the EC-BOS-6
AX
Step 6 Repeat this for all accessories, until all are mounted on the DIN rail and firmly connected to each other.
Step 7 To keep the final assembly together, secure at both ends with DIN rail end-clips provided by the DIN
rail vendor. This also prevents the assembly from sliding on the DIN rail. See Figure 1 below.
Figure 1 EC-BOS-6
AX
and accessory mounting details.
Mounting on DIN Rail Removing from DIN Rail
EC-BOS-6
AX
EC-BOS-6
AX
345 mm (13.58”)
162 mm (6.38”)
104 mm
(4.1”)
162 mm (6.38”)
EC-NPB-PWR
Install DIN rail End Clip
(Stop Clip) at both ends of
final assembly.
DIN rail
End Clip
DIN Rail
End Clip
EC-NPB-PWR
263 mm (10.35”)
509 mm (20.04”)
427 mm (16.81”)
591 mm (23.27”)
52 mm
(2.05”)
EC-BOS-6
AX
181 mm (7.13”)
IO-16 (1)
IO-16 (2)
IO-16 (3)
IO-16 (4)
EC-NPB-PWR
IO-16
Up to four (4)
EC-Net
AX
IO-16
modules are
supported.
NOTE: If installing
EC-Net
AX
IO-16
modules and using the
EC-NPB-PWR or
EC-NPM-PWR-UN
power supply module,
the power supply
module installs at the
end of the chain.