Ditch Witch 1820 - Control Descriptions (Continued); Ignition Switch and Voltmeter Operation

1820 - CONTROLS 15
CONSOLE
1820 - CONTROLS 15
CONSOLE
Ignition Switch
This switch is used to start engine.
Gasoline Engines:
• Insert key and turn it clockwise to
start position (C).
• When engine starts, release key. It
will return to on position (B).
• If engine does not start or is killed, turn switch to off position
(A), then restart.
Diesel Engines:
• Insert key and turn it clockwise to on position (B). Glow plug
indicator will light as engine heats.
• When glow plug indicator goes out, turn key to start position
(C).
• When engine starts, release key. It will return to on position
(B).
• If engine does not start or is killed, turn switch to off position
(A), then restart.
Voltmeter
This gauge measures voltage in
electric system. Reading should be
between 12 and 15 volts with engine
running. If not, stop engine and
investigate.
ic1084
om1132.pcx
Ignition Switch
This switch is used to start engine.
Gasoline Engines:
• Insert key and turn it clockwise to
start position (C).
• When engine starts, release key. It
will return to on position (B).
• If engine does not start or is killed, turn switch to off position
(A), then restart.
Diesel Engines:
• Insert key and turn it clockwise to on position (B). Glow plug
indicator will light as engine heats.
• When glow plug indicator goes out, turn key to start position
(C).
• When engine starts, release key. It will return to on position
(B).
• If engine does not start or is killed, turn switch to off position
(A), then restart.
Voltmeter
This gauge measures voltage in
electric system. Reading should be
between 12 and 15 volts with engine
running. If not, stop engine and
investigate.
ic1084
om1132.pcx