JT30 /JT30 All Terrain Operator’s Manual Systems and Equipment - 154
Drill Pipe
CMW
Use Drill Pipe Correctly
Align the Joints
Always carefully align the male and female
ends of pipe before threading them together.
Poor alignment can damage the threads and
destroy the usefulness of the joint.
Clamp Pipe Correctly
Clamp on pipe when joint is between
wrenches. Clamp only on the tool joint of the
drill pipe as shown. This portion of the drill
pipe is designed for clamping and is
considerably thicker and stronger than the
rest of the pipe.
See “Clamp Pipe” on page 105 for more
information.
NOTICE: If joints get out of alignment
during a bore, use frame tilt or rear
stabilizers to adjust the unit.
NOTICE: Clamping anywhere else on the
pipe will weaken the pipe. Pipe can later
break, even when operating under normal
loads.
To Next Page
Loading...