JT30 /JT30 All Terrain Operator’s Manual Service - 230
As Needed
CMW
Change Drive Belt
Change engine drive belt as needed.
JT Units:
1. Turn off engine and remove key.
2. Use a 1/2” drive rachet at pulley (1) to remove
tension.
3. Remove belt (2).
4. Install new belt.
All Terrain Units:
1. Turn off engine and remove key.
2. Remove snap ring (3) from groove and slide
pump coupler collar (4) back.
3. Use a 1/2” drive rachet at pulley (1) to remove
tension.
4. Remove belt (2).
5. Install new belt.
6. Slide pump coupler collar back into position
and reinstall snap ring.
To Next Page