Ditch Witch JT30 - Page 232

JT30 /JT30 All Terrain Operator’s Manual Service - 232
As Needed
CMW
Check Pipeloader Chute Opening
Check chute openings and adjust per dimension as
needed.
1. JT chute opening (shown) = 3.35” (8.5 cm).
2. AT chute opening (shown) = 3.60” (9.1 cm).
Apply Loctite
®
242 to bolts.
Check Wrench Jaw Inserts
Check wrench jaw inserts for wear and replace as
needed.
Replace Pipe Guide Blocks
Check pipe guide blocks for wear. Replace as
needed.
To replace:
Remove pins (1) and remove guide blocks (2).
Install new pins. See your Ditch Witch dealer for
replacement parts.