Ditch Witch JT30 - Page 50

JT30 /JT30 All Terrain Operator’s Manual Controls - 50
Information Center
CMW
2. ESID display Displays the ESID
information.
IMPORTANT: If a strike is detected,
the bottom portion of the display
automatically switches to the ESID
information display.
3. Drilling fluid flow
display
Displays the estimated GPM
or LPM of drilling fluid being
pumped.
4. Outer rotation speed
display
Displays the measured RPM
of outer rotation pipe.
5. Inner rotation speed
display
Displays the measured RPM
of inner rotation rod (AT only).
6. Operation and
exception message
display
Displays status of cruise
control, carve mode, drill fluid,
tracker control, diagnostic test
mode and service mode.
Displays exception messages when a
requested function is blocked due to a
conflicting condition.
7. Pipeloader message
display
Displays messages related to
add or remove pipe cycles.
Displays diagnostic
information when unit is in
service mode.
8. Diagnostic message
display
Displays messages related to
diagnostic information of
machine.
9. Active display indicator Indicates that information
center display is operating.
IMPORTANT: If nothing is changing
on the display except this indicator,
communications may have stopped.
10. Diagnostic indicator Indicates diagnostic codes
(dc) from main controller,
ESID, or Information Center.
Device shown is the source of the
diagnostic code shown.
Item Description Notes