DITEC DAB105 User Manual (English)

Other manuals for DITEC DAB105

Questions and Answers:

V
Vicki GonzalezAug 5, 2025
Why DITEC Door Opening System doesn't open?
- C
  Connie BowersAug 5, 2025
  There are several reasons why your DITEC Door Opening System might not be opening. First, check if the function selector is set to OFF and change it if it is. Second, ensure that there is a mains power supply. Third, verify the connections of the command accessories, as the command unit may not be working. Fourth, make sure that the motion sensor has not been activated by removing any objects from the detection area. Fifth, check if the emergency closure has been activated and deactivate it. Finally, ensure the SPTE trimmer is set to 0°.
T
Timothy Wilson DDSAug 13, 2025
What to do if DITEC DAB105 doesn't close?
- N
  nsullivanAug 13, 2025
  If your DITEC Door Opening System isn't closing, it could be due to a few reasons. Check if the function selector is set to DOOR OPEN and change the setting. Also, verify that the motion sensor contact hasn't been activated by removing any obstructions from the detection area. Finally, make sure there are no obstacles blocking the door's path.
K
Karen RobertsAug 20, 2025
What to do if DITEC Door Opening System motor starts but the door doesn't move?
- M
  Maria JohnsonAug 21, 2025
  If the motor in your DITEC Door Opening System starts but the door doesn't move, check for the following issues. A mechanical lock might be blocked, so release it. There might be an obstacle in the door's path, so remove it. The door stop could be jammed, so select block release. Also, the arm system might be coming loose; in this case, rotate the SPTE trimmer until the door stop is on the limit switch, bring the door to its open position, tighten the arm system, and rotate the SPTE trimmer to 0°.
L
Laura CooperAug 28, 2025
What to do if the spring pre-tensioning on DITEC automatic Door Opening System is unrecognised?
- M
  matthewgilbertAug 28, 2025
  If the spring pre-tensioning on your DITEC automatic Door Opening System is unrecognised, it may be due to too many adjustments. Here's what you should do: 1. Rotate the SPTE trimmer until the end stop can be loosened. 2. Remove the end stop and the arm system. 3. Disconnect the mains power supply. 4. Disconnect the motor cable. 5. Replace the arm system and locate the non-pretensioning point by moving the door wing backwards and forwards. 6. Loosen the arm. 7. Reconnect the motor cable. 8. Reconnect the mains power supply. 9. Adjust the SPTE trimmer at 210° and wait for the shaft to stop rotating. 10. Fix the end stop on the closure limit switch. 11. Set the SPTE trimmer to 0°. The automatic system has returned to the factory settings. 12. Repeat the door start-up operations.