dixell xc440c User Manual


Operating instructions cod. 1592001300
1592001300 XC440C gb r1.0 07.06.2004.doc rel. 1.0
Pa
g
e
12 / 28
10. Use of the programming “HOT KEY “
10.1 How to program a hot key from the instrument (UPLOAD)
1. Program one controller with the front keypad.
2. When the controller is ON, insert the “
Hot key
” and push
9
9
key; the
"uPL"
message
appears followed a by flashing
“End”
3. Push “
SET”
key and the
End
will stop flashing.
4. Turn OFF the instrument remove the
“Hot Key”,
then turn it ON again.
NOTE
: the “
Err
” message is displayed for failed programming. In this case push again
9
9
key if
you want to restart the upload again or remove the “
Hot key
” to abort the operation.
10.2 How to program an instrument using a hot key
(DOWNLOAD)
1. Turn OFF the instrument.
2. Insert a
programmed “Hot Key” into the 5 PIN receptacle
and then turn the Controller
ON.
3. Automatically the parameter list of the
“Hot Key”
is downloaded into the Controller
memory, the “
doL
” message is blinking followed a by flashing
“End”.
4. After 10 seconds the instrument will restart working with the new parameters.
5. Remove the
“Hot Key”.
.
NOTE
the message “
Err
” is displayed for failed programming. In this case turn the unit off and
then on if you want to restart the download again or remove the “
Hot key
” to abort the
operation.
The unit can UPLOAD or DOWNLOAD the parameter list from its own E2 internal memory to
the
“Hot Key”
and vice-versa.
11. Keyboard locking
11.1 How to lock the keyboard
1. Keep the
9
9
and
8
8
ke
y
s pressed to
g
ether for more than 3 s the
9
9
and
8
8
keys.
2. The “POF” messa
g
e will be displa
y
ed and the ke
y
board is locked. At
this point it is onl
y
possible to view the set point or enter the HACCP
menu.
11.2 To unlock the keyboard
Keep the
9
9
and
8
8
keys pressed together for more than 3s till the “
POn”
flashing message
appears.

dixell xc440c Specifications

General

Brand	dixell
Model	xc440c
Category	Controller
Language	English