Page 8 of 72
CLEANING THE VENDER
DO NOT USE A WATER JET OR NOZZLE TO CLEAN THE VENDER.
SIGN FACE
The polycarbonate sign face requires proper cleaning to prolong the service life of this item. It is
recommended that you periodically clean the sign face as follows:
1. Rinse the sign with a soft cloth or sponge soaked in warm water.
2. If necessary, use a mild soap to loosen any dirt or grime. To prevent damage, DO NOT
SCRUB or use a brush or squeegee, as some signs have a clear ultraviolet resistant coating to
prevent yellowing.
3. Repeat the above steps as necessary, then dry using a soft cloth to prevent spotting.
CABINET
* Wash the cabinet with a good detergent or soap mixed in warm water.
* Wax the vender often with a good grade of automobile wax.
* Any corrosion inside the vender should be removed with fine steel wool and the area should be
painted with aluminum paint.
• Repair any scratches on painted surfaces to prevent corrosion.
WARNING: THE COMPRESSOR ELECTRICAL CIRCUIT IS ALWAYS LIVE WHEN THE
PLUG IS CONNECTED TO AN ELECTRICAL OUTLET.
REFRIGERATION CONDENSER
* Check the condenser periodically for dirt or lint build up.
* Remove the build up with a brush or vacuum, or blow the dirt out of the condenser with
compressed air and approved safety nozzle.
* Ensure nothing obstructs air intake at the bottom of the main door.
* Ensure nothing obstructs air exhaust at the rear of the cabinet.
COIN ACCEPTOR
* Follow the Coin Acceptor Manufacturer's instructions.
To Next Page
Loading...
