10
©
2018 DJI All Rights Reserved.
AGRAS MG-1P SERIES Quick Start Guide
To remove the Intelligent Battery, open the cover, press and hold the battery release button, then push the battery downward.
Mounting the Dongle
Only use a DJI approved dongle.
The dongle supports various network standards. Use a SIM card that is compatible with the chosen mobile network
provider and select a mobile data plan according to the planned level of usage.
Use the dongle and the SIM card in accordance with their manuals.
The dongle and SIM card are used to enable the remote controller to access to specic networks and platforms, such as
the DJI Agriculture Management Platform. Be sure to mount them correctly, or else network access will not be available.
1. Lift the dongle compartment cover at the gap at its lower right corner, then remove it.
2. Insert the SIM card into the dongle and then insert the dongle into the USB port inside the compartment. Test
to ensure that they function properly.*
3. Cut the connecting string between the dongle cap and dongle body if there is one.
4. Re-mount the dongle compartment cover. To secure the cover, open the silicone protectors on the cover, insert
and tighten two M1.6×3 screws, then close the silicone protectors.
Battery Release Button
2
3
Mounting the Remote Controller Battery
The remote controller uses a removable, interchangeable Intelligent Battery making long-term
operation easy.
Slide the battery compartment cover lock on the back of the remote controller down to open the
cover
1
, insert the Intelligent Battery into the compartment and push it to the top
2
, then close the
cover
3
.
* Test procedure: Press the remote controller power button once, then press again and hold to turn the remote controller on. In the
DJI MG app tap and select Network Diagnostics. If the statuses of all the devices in the network chain are shown in green the
dongle and SIM card are functioning properly.
To Next Page
Loading...
