dji AGRAS MG-1P Series - Installing Spray Tank and Frame Arms

To Next Page

To Previous Page

AGRAS MG-1P SERIES Quick Start Guide

Try to keep the aircraft inside the optimal transmission zone. If the signal is weak, adjust the antennas or y the

aircraft closer.

Avoid using wireless devices that use the same frequency bands as the remote controller.

Getting Ready for Takeoff

When using your MG-1P / MG-1P RTK for the rst time activate it using the DJI MG app. Your DJI account and an

Internet connection are required.

1. Place the aircraft on an open, at ground with the Aircraft Status Indicators facing toward you.

2. Unfold the propellers and check that they are mounted onto the motors securely. Unfold the frame arms and

tighten the arm sleeves rmly.

3. Power on the remote controller.

4. Ensure the battery is securely mounted. Connect the battery to the power port on the aircraft.

Optimal Transmission Zone

4. The Aircraft Status Indicators show the current ight mode and the calibration page disappears in the app when

calibration is complete. If the Aircraft Status Indicators blink red or a calibration failure is displayed in the app,

repeat the steps above to calibrate the compass.

Calibrating the Compass

1. Go to the app and tap Perform an Operation to enter Operation View. Tap the Aircraft Status Bar at the top of

the screen and select Calibration in the Aircraft Status List, then follow the on-screen instructions.

2. Hold the aircraft horizontally and rotate it 360 degrees around a vertical axis until the Aircraft Status Indicators

change to solid green and the display goes to the next step in the app.

3. Hold the aircraft vertically, with its nose pointing upward, and rotate it 360 degrees around a vertical axis.

Other manuals for dji AGRAS MG-1P Series