dji AGRAS MG-1P Series - Product Profile and Features; Introduction to AGRAS MG-1 P Series; Key Feature Highlights

To Next Page

To Previous Page

AGRAS MG-1P SERIES Quick Start Guide

Mounting the Radar Module

1. Mount the radar bracket to the radar module using four M3×5.5 screws, with the bracket crossbar over the

radar cable as shown in the gure below.

Power Port

Stud

Belt

The MG-1P and MG-1P RTK do not come with a battery. Please purchase the DJI approved MG-1P battery pack (Model:

MG-12000P).

The voltage on the aircraft can reach 50.4 V. Read the battery’s safety guidelines and take necessary precautions when

handling the battery to ensure your own safety.

Mounting the Flight Battery

Insert the battery into the battery compartment from the front of the aircraft. Ensure the battery is securely

mounted and then fasten the belt to the stud on the spray tank.

2. Unfasten the buckles on the bracket then mount it to the left landing gear leg. Align the bracket to the lower

marks on the landing gear leg. Fasten the buckles and secure them using four M3×5.5 screws.

3. Insert the radar cable into the cable clip on the landing gear leg, then connect it to the radar port on the aircraft

body.

Marks

Other manuals for dji AGRAS MG-1P Series