dji AGRAS MG-1P Series - Unfolding the Frame Arms; Mounting the Sprinklers

AGRAS MG-1P SERIES Quick Start Guide
©
2018 DJI All Rights Reserved.
7
M1M2
M3
M4
M5 M6
M7
M8
Unfolding the Frame Arms
1. Unfold the frame arms
1
and tighten the two arm sleeves at each of the junctions
2
.
2. Identify the position and rotational direction of the motors. The top view shows motors M1 to M8 arranged in a
counter-clockwise order, with motors M1 and M2 at the front of the aircraft, and motors M5 and M6 at the rear.
Motors M1, M3, M5, and M7 rotate counter-clockwise as indicated by the “CCW” mark, while motors M2, M4,
M6, and M8 rotate clockwise as indicated by the “CW” mark.
Mounting the Sprinklers
1. Mount the hose clips: Mount one hose clip to the bottom of each of the four frame arm junctions using T3×10
screws. Mount one hose clip to the outside of the right landing gear leg mounting position using an M3×6
screw.
M3×6T3×10