dji AGRAS MG-1P Series - Operation and Maintenance; Aircraft Operation Guidelines; Maintenance and Upkeep Procedures; Legal Compliance and Regulations

AGRAS MG-1P SERIES Quick Start Guide
©
2018 DJI All Rights Reserved.
5
Installation
4. Mount the left landing gear leg and secure it in place using three M3×10 screws.
Mounting the Power Port Module
Mount the power port module onto the left landing gear leg using two M3×18 screws and one M3×22 screw.
Mounting the Landing Gear
1. Identify the landing gear leg containing the compass cable.
2. Take out the compass cable from the tube of the landing gear leg and connect it to the compass port on the
aircraft’s right side, then mount the right landing gear leg to the mounting position. Be careful not to damage
the cable.
3. Secure the right landing gear leg in place using four M3×10 screws.
Threadlocker of medium strength is required for installation. Apply threadlocker when mounting the landing gear, power
port module, spray tank, sprinklers, and radar module. Ensure the threadlocker is totally dry and solid before ight.
DO NOT bend the hoses in an arc tighter than their minimum bend radius during installation. This is to avoid creasing,
which may compromise the spraying eect.
Ensure that all installation and connection procedures are completed before powering on the aircraft.
Aircraft Rear
M3×18
Insert into the upper
screw hole
M3×18
M3×22
The installation steps are the same for both the MG-1P and MG-1P RTK. In the figures below the
MG-1P is shown.
Compass Port
Compass Cable