dji AGRAS MG-1P Series - Mounting the Spray Tank

To Next Page

To Previous Page

AGRAS MG-1P SERIES Quick Start Guide

Mounting the Spray Tank

1. Connect the sprinkler kits to the spray tank: Pull the four hoses through the nuts to the outlets under the

delivery pump, then tighten the nuts using a wrench. Note that the white and black hoses should be attached

to outlets with labels of the same color. Be sure to securely tighten the nuts to avoid liquid leakage.

2. Remove the cover of the spray tank. Pull the hoses on both sides through the spaces between the two tubes

of each landing gear leg with the mouth of the tank facing toward the right side of the aircraft.

3. Lift the spray tank and pull the mouth of the tank through the space between the two tubes of the right landing

gear leg.

4. Insert the plugs on the left landing gear leg into the mounting holes on the spray tank.

5. Slide the xing bracket on the right landing gear leg to the marks on the tubes to align the screw holes on the

xing bracket with the n on the right side of the spray tank. Tighten the two M3×12 screws and insert and

tighten one M3×10 (Plus) screw.

6. Connect the two pump cables and one liquid level meter cable to their corresponding ports on the aircraft

body.

M3×12M3×12

M3×10 (Plus)

Marks

Other manuals for dji AGRAS MG-1P Series