dji AGRAS MG-1P Series - Installation Guide; Mounting Landing Gear and Power Module

AGRAS MG-1P SERIES Quick Start Guide
©
2018 DJI All Rights Reserved.
13
Using the MG-1P / MG-1P RTK
Preparing the Flight Battery
Only use DJI approved flight batteries (Model: MG-12000P). Check
the battery level before ying and charge according to the instructions
provided by the manufacturer.
Press once to check the battery level. Press once,
then again and hold to turn on/o.
Charging the Battery
The remote controller uses a removable Intelligent Battery. Press the battery level button once to
check the battery level. Fully charge the batteries before first-time use.
Place the battery into the Charging Hub, connect the AC power adapter to the Charging Hub, and
then connect the AC power adapter to a power outlet (100 - 240V, 50/60Hz).
Adjusting the Antennas
Tilt the display device on the remote controller to the desired position, then adjust the antennas so they are facing
outward. The strength of the remote controller signal is aected by the position of the antennas.
Strong Unfold
Weak
Preparing the Remote Controller
Checking Battery Level
Model: MG-12000P
AC Power Adapter
Charging Hub
Power Outlet
Low High