dji GOGGLES N3 - Page 13

To Next Page

To Previous Page

c. Once linking is completed, the battery level LEDs of the aircraft turn solid and

display the battery level, the goggles stop beeping, and image transmission can be

displayed normally.

2. Linking the goggles and remote control device:

5s 5s3s

a. Press and hold the power button on the goggles until the goggles start to beep

continuously and the power button starts to blink yellow.

b. Press and hold the power button on the remote control device until it starts to

beep continuously and the battery level LEDs start to blink in sequence.

c. Once linking is completed, the goggles and remote control device stop beeping

and display the battery level.

• The aircraft can be controlled with only one remote control device during ight.

If the aircraft has been linked with multiple remote control devices, turn o the

other remote control devices before linking.

DJI Goggles N3 User Manual