dji GOGGLES N3 - Formatting the SD Card; Liveview Sharing; Wired Connection with Smartphone

To Next Page

To Previous Page

The screen recording includes the OSD elements by default. To record the screen without

the OSD elements, change the settings as shown below:

1. Open the goggles menu.

2. Select Settings > Camera > Advanced Camera Settings, and disable Camera View

Recording.

Formatting the SD Card

To format the microSD card, follow the steps as shown below:

1. Open the goggles menu.

2. Select Settings > Camera > Format.

3. Select the storage device to format and follow the on-screen instructions to complete

the operation.

• Data cannot be recovered after formatting. Operate with caution.

5.5 Liveview Sharing

DJI Goggles N3 can share a ight liveview via the following methods.

• Power on the aircraft, goggles, and remote control device. Make sure all the

devices are linked.

• Operate Liveview Sharing prior to taking o, or when the aircraft is braking or

hovering, to avoid interfering with the pilot's operation.

• The goggles only support connecting to one smartphone for sharing the liveview

at a time. Other smartphones cannot be connected during this period.

• When connected to a smartphone, liveview sharing will be paused when viewing

the images or videos in the album. Exit the album to recover sharing.

• When using the broadcasting mode, the audience and the pilot goggles must

select the same aircraft model.

Wired Connection with Smartphone

1. Connect the USB-C port of the goggles to the smartphone.

2. Launch DJI Fly app and tap GO FLY in the lower right corner of the screen to enter the

liveview.

DJI Goggles N3 User Manual