Visit the following link and refer to the Release Notes for rmware update information:
https://www.dji.com/goggles-n3/downloads
7.3 Compatibility
Visit the following website to get the information on compatible products.
https://www.dji.com/goggles-n3/faq
7.4 Risk and Warnings
When the aircraft detects any risk after powering on, there will be a warning prompt on
the goggles screen. Pay attention to the prompt during ight and take necessary actions
accordingly to avoid product damage or risk of injury.
If the Signal Lost Action of the aircraft is set to RTH, when the control signal or
transmission is lost during ight, the aircraft will automatically initiate Failsafe RTH and y
back to the last recorded Home Point.
In emergency situations during ight, such as if a collision occurs, a motor stalls, the
aircraft rolls in the air, or the aircraft is out of control and is ascending or descending
quickly, the motors can be stopped by pressing the motion controller lock button four
times.
• Stopping motors mid-ight will cause the aircraft to crash. Operate with caution.
If the goggles screen goes o unexpectedly during ight, press the motion controller lock
button once to brake the aircraft rst, and then initiate RTH manually. After the aircraft is
back, check the goggles power level and try to restart the goggles. If the problem persists,
contact DJI support.
7.5 Troubleshooting
1. Power-on and start-up problems
Check if the battery has power. Contact DJI support if it cannot be started normally.
2. Power-o and shutdown problems
Contact DJI support.
3. The device is not functioning after powering on.
Contact DJI Support.
DJI Goggles N3 User Manual
26 © 2024 DJI All Rights Reserved.
To Next Page
Loading...